Page 1 of 1

Modular Aenglish watchman design question - now with Poll

PostPosted: Sun Nov 27, 2011 10:15 pm
by Gutbukkit
Tre cant log in wrote:Hey guys, I am wrapping up the 1st modular Aenglish watchman / militiaman and I am tryign to decide whether or nto to make the shield a modularly interchangeable otion. As of right now the shield is integral to the body with the only modular parts being the head and collar and the weapon arm. There will be probably 4 head / collar options and 4 weapon arm options ( each with a different weapon; guisarme, hammer, flail, sword ).

The default shield will be a straight up kite shield but I had though to make a norman shield type, a round shield, and a heater.

Can't make a poll as a FG so if you feel so inclined...... you can just say yes or no.

PostPosted: Sun Nov 27, 2011 10:52 pm
by Tre cli
Cheers Gutbukkit! Thanks. :beer:

PostPosted: Sun Nov 27, 2011 10:57 pm
by Gutbukkit
No worries :D

PostPosted: Sun Nov 27, 2011 11:09 pm
by The Masked Frother
Ideally the shields should match the sizes of one of the brands offered by Litle Big Men studios! 8)

PostPosted: Mon Nov 28, 2011 12:30 am
by tre nli
Yeh I wish had a few of those on hand to match to. Any diea on dimensions?? widest, middle and most narrow points.

PostPosted: Mon Nov 28, 2011 1:19 am
by Blackie's Left Boot
Well, the beauty of separate shields is you can substitute an LBMS-sized one from the spares box with no issues.

PostPosted: Mon Nov 28, 2011 5:08 pm
by Vermis
Gutbukkit wrote:No worries :D


You really shouldn't enable him.