by Tre still can't log in » Sun Jan 22, 2012 9:36 pm
well these pieces are going to fall down easy to assemble. I am making deep socket and peg fittings that will allow you to dab a bit of glue / putty, place, and forget.
This is a pretty close toss up. If I cast my own vote this poll would be 9 for single part characters and 8 for conversion kits.
I have the would-be standard bearer figure done now and the musician is about 75% done. Figure I should have these done tomorrow and en route to production by wednsday. From there it just depends how long it will take to get the figures through the production cycle.

well these pieces are going to fall down easy to assemble. I am making deep socket and peg fittings that will allow you to dab a bit of glue / putty, place, and forget.
This is a pretty close toss up. If I cast my own vote this poll would be 9 for single part characters and 8 for conversion kits.
I have the would-be standard bearer figure done now and the musician is about 75% done. Figure I should have these done tomorrow and en route to production by wednsday. From there it just depends how long it will take to get the figures through the production cycle.
:D :D :D :D